3D Cross Magnet

Bottom:

Top:

Materials Used:
7 count Plastic Canvas Mesh
Needloft Yarn:
#41 White - 6 yds.
#00 Black - 3 yds.
To Finish Project:
#310 Pearl Cotton Black - 1 yd.
4" strip of sticky backed magnet

Stitches Used:
Continental Stitch
Reverse Continental Stitch
Embroidery Backstitch
Overcast Stitch

Instructions:
Cut 1 piece of canvas 26X32 threads (25x31 holes) according to the pattern (top
cross). Follow the pattern (top cross) to stitch the project. Using #310 Pearl
Cotton Black thread stitch the detail lines. Overcast the entire project in
black. Cut 1 piece of canvas 30X36 threads (29X35 holes) according to the pattern
(bottom cross). Follow the pattern (bottom cross) to stitch the project. DO
NOT stitch in uncoded section. Overcast the entire project in black. Placing the
top cross onto the unstitched area of the bottom cross, tack down with some white
yarn on all 4 points of the cross. Put a little glue on the back of the bottom
cross, we used Aleene's Clear Gel Tacky Glue, and then put the sticky backed
magnet piece on top of that. Press down really hard and possibly even put a
heavy book on top so it will keep it stuck. We found that using some glue helped
keep the magnet on better.